EDER ALGEMA-FITZEL BLITZLADER 2 Operating Instructions Manual page 71

Eder GmbH
Oil change:
•
Change the oil once a year.
•
First unscrew the cap of the filler opening so that there is no underpressure in the oil
tank.
•
Place a suitable aid (funnel, gutter, drip tray) under the drain plug.
•
Carefully open the drain plug and slowly drain the oil. It is normal that a small
amount of hydraulic oil remains in the tank.
•
The used oil must be collected and disposed of properly.
•
Then screw the drain plug back in. It is sufficient to hand-tighten the screw. The screw
and the immediate vicinity should be cleaned of residues before filling with new
hydraulic oil, so that possible leaks at the drain plug can be detected immediately.
•
Using a suitable funnel, refill hydraulic oil HLP22 according to DIN 51524 until the
oil tank is filled to approx. two centimetres below the lower edge of the filler
opening. The changed oil quantity is approx. three litres.
•
Then screw the lid back in hand-tight.
•
Remove any possible dirt and check the tightness of the drain plug again.
Operating Instructions Algema Blitzlader 2 Air - Edition
5 Care and
71/ 100