EDER ALGEMA-FITZEL BLITZLADER 2 Operating Instructions Manual page 58

4 Operation and use
•
Then stow the jack, tools and the defective wheel.
•
Check the tightening torque of the wheel bolts again after 50 km.
The car transporter can slip off the jack during the wheel change!
The wheel bolts are not tightened with the correct torque!
Wheel change with loaded car transporter!
Flowing traffic when changing wheels on public roads!
58/ 100
People lying under the car transporter can be crushed.
°Use jacks with a rubberised support surface or place a suitable
anti-slip mat on the support surface of the jack.
°When lifting, make sure that the support surface of the jack does
not slip. This can happen, especially with a manoeuvring jack,
due to the circular movements of the lifting arm.
°Do not lie under the car transporter while changing the
wheel.
°Do not reach further under the car transporter than absolutely
necessary for the wheel change.
The wheel may come loose after the wheel change.
The rim, wheel bolt or wheel hub can be damaged.
°Tighten the wheel bolts with a torque spanner. Refer to the
operating instructions of the base vehicle for the tightening
torque. It is identical for both rear axles.
If no torque spanner is available when changing the wheel,
the tightening torque must be checked as soon as possible in a
suitable workshop.
The axles or wheels can be overloaded and damaged.
°Wheel changing with a loaded car transporter is not allowed.
Unload the car transporter before changing the wheel.
Accidents with personal injury and property damage may occur.
° Secure yourself sufficiently against moving traffic. Apply the
identical measures as for loading and unloading
and unloading point", page 20).
Operating Instructions Algema Blitzlader 2 Air - Edition
Eder GmbH
(see "Loading