EDER ALGEMA-FITZEL BLITZLADER 2 Operating Instructions Manual page 30

4 Operation and use
•
Secure the loaded vehicle
•
Detach the rope hook from the loaded vehicle and hook it into the storage eye (4).
•
Pull in the rope until it hangs loosely.
•
Finally, activate the freewheel of the cable winch.
The cable winch is used to tie down the vehicle!
After loading, reactivate the winch freewheel. If the free wheel of the
cable winch remains deactivated, it can happen that an unintentional
(e.g. radio remote control in the trouser pocket) may cause damage to the
winch, the storage eyelet or the loaded vehicle!
The battery voltage is not monitored during winch operation. Due to the
high current demand of the winch, it is possible that the battery voltage
The vehicle's batteries will be discharged after a short time if the engine
is not running.
The figure-of-eight loop is damaged!
30/ 100
(see "Securing the loaded vehicle", page 23).
Vehicle or winch may be damaged.
Never use the winch to tie down the vehicle.
Injuries caused by the figure-of-eight
sling The figure-of-eight sling can tear.
°The same criteria apply as for the winch rope
ropes", page 67).
Operating Instructions Algema Blitzlader 2 Air - Edition
Eder GmbH
A figure-of-eight sling is supplied with every
car transporter with a cable winch. The
figure-of-eight sling serves as an aid if the
hook of the cable winch cannot be easily
attached to the vehicle to be loaded. To do
this, pass the sling through the towing eye
or a load-bearing part of the vehicle to be
loaded. If necessary, slightly compress the
loops of the sling. Then hook both loops
into the hook of the winch as shown.
(see "Testing