EDER ALGEMA-FITZEL BLITZLADER 2 Operating Instructions Manual page 87

Eder GmbH
Error
Ramps can no
longer be moved in
or out with the
electrohydraulics
Cable winch does
not work
Operating Instructions Algema Blitzlader 2 Air - Edition
Cause
Shift paddles at the
end of the plateau
do not touch the
floor
Discharge
vehicle battery
Set-up functions
are not switched
on
Function for manual
control or radio
remote control not
correctly selected
Oil level of the
electro-hydraulics too
low
Check status
LEDs on power
unit
Defect cannot be
found or rectified
Discharge
vehicle battery
Set-up functions
are not switched
on
Check status
LEDs on power
unit
Remedy
Only load and
unload the car
transporter on
level ground.
Start the engine, if
necessary start it
externally
Switching on the
set-up functions on
the touch panel
Activate the manual
control or radio
remote control
function as desired.
Check oil level and
top up if necessary
Status LEDs no. 05
or 06, 08 or 15,
10, 13, 16 and 17
must be green,
contact specialist
workshop if
necessary
Retract or extend
drive-up ramps by
hand in emergency
mode
Start the engine, if
necessary start it
externally
Switching on the
set-up functions on
the touch panel
Status LEDs no. 11
or 12, 08 or 15,
10, 13, 16 and 17
must be green,
contact specialist
workshop if
7 Additional
Chapter
See "Safety
instructions for
loading and
unloading", page
16.
Operating instructions
base vehicle
see "Tilt plateau
operation ", page
21
see "Tilt plateau
operation ", page
21
see "Checking the
oillevel and oil
change", page 70
see "Power unit",
page 75
see "Emergency
operation
electrohydraulics",
page 51
Operating instructions
base vehicle
see "Tilt plateau
operation ", page
21
see "Power unit",
page 75
87/ 100