Command And Response Table For Sis Commands - Extron electronics SW USB Series User Manual

Command and Response Table for SIS Commands

ASCII Command
Command
(Host to Unit)
Input Selection
Select input X!
X!
Select SW USB input
only
Hot Key
Enable and disable hot E
key
E
View hot key status
Configure RS-232 Pass-through
Send SIS commands E
via computer RS-232
interface
Send input selection E
commands via contact
closure, front panel,
or the RS-232 interface
View loop-through E
setting
Front Panel Lockout (Executive Mode)
Enable executive mode
1X
Disable executive mode
0X
Lockout status X
Information Requests
Request information
I
Request part number
N
Query firmware version
Q
Example: Q
Query version and build
*Q
Response
(Unit to Host)
! Chn
^ Usb
X@ }
H USBC UsbcH
} X@ ]
H USBC
}
1LOOP Loop1
}
0LOOP Loop0
}
LOOP Loop
Exe1
Exe0
X# ]
Chn
60-95n-nn
n.nn
1.01
n.nn.nnnn ]
Additional Description
X! ]
Select input
the attached AV switcher (if any).
X! 1
= ,
X! ]
Select input
passed through).
X@ ] Enable and disable the hot key function.
X@
For :
1
= enabled
0
= disabled
Display current hot key status
] Pass SIS commands through the RS-232
Pass Thru port to the AV switcher only if
the commands are sent to the SW USB
via the computer RS-232 interface.
] Pass all SIS commands sent from the
computer RS-232 interface, and only
input selection commands sent via the
front panel or contact closure, to the AV
switcher via the RS-232 Pass Thru port.
X# ]
View pass-through setting
0
= Loop 0 mode is enabled.
1
= Loop 1 mode is enabled.
] Lock the front panel.
] Unlock the front panel.
Show executive mode on/off status.
X#
For :
X! X$ X$
• InACT • OutACT
Show the selected input and output.
X$
= Activity of all inputs and outputs
For SW USB Plus only:
X%
= Mouse emulation switch position
X^
= Keyboard emulation switch position
X%
For and
] Show the SW USB part number.
SW2 =
SW4 USB Plus =
] Show firmware version, expressed to the
second decimal place.
]
The unit firmware version is
Show firmware version and build number.
SW USB Series • SIS Programming and Control
X!
for both the SW USB and
2 3 4
, , or .
X!
on the SW USB only (not
X@
.
X# X#
. For :
1 0
= on, = off
X% X^ ]
• Emul
X^ 0 1
: = off (down); = on (up)
60-952-02 60-953-02
, SW4 =
60-954-02
.
1.01
.
,
29