GE LOGIQ V3 Basic Service Manual page 237

8-3-7-2 Wipe Tool(continued)
NOTE:
8-3-7-3 Loading the system with USB memory stick
NOTE:
NOTE:
NOTE:
LOGIQ V3/V5/V5 Expert – Basic Service Manual
5726264-100 English Rev.8
Figure 8-7. Process Complete
As the SSD is empty after wipe tool, the system cannot boot
up. The software should be loaded first after the wipe tool.
While it is believed to be unnecessary, it would not hurt to
disconnect the system from the network and remove all
transducer.
Please ensure AC adapter is connected during system upgrade!
Serial number and option key are needed to be input after
loading the complete disk. The serial number abd option key
MUST be the same as the ones before installation. Please
record the serial number and option key before installation.
1. Insert the USB memory stick labeled "System & Application
Software" to the system.
Loading the software
8-15