Alcatel-Lucent 9500 MPR User Manual page 92

Signal Mode .
Configures framing detector on
P2E3DS3 module.
Service Profile. Provisioning Rules:
1. DS3 Port Service Profile provisioning must be the same at
both ends of the link.
2. DS3 ports 1 and 2 can be provisioned independently.
3. Provisioning a DS3 port TDM2TDM prevents cross-
connecting that DS3 port to Ethernet access ports 1-4.
4. Flow ID number is unique for that DS3 port and once
assigned, cannot be repeated throughout the network.
Figure 4 - 17 P2E3DS3 Module Provisioning TDM2TDM (Sheet 2 of 2)
4-40
Select:
•
Disabled – No alarm and no AIS insert.
•
Unframed – Insert AIS on LOS (Tx & Rx).
•
Framed – Insert AIS on LOF and LOS (Tx & Rx).
Apply settings
for this port
number.
TDM2TDM
NOTE: DS3 required TDM2ETH Service Profile.
In TDM2TDM mode, the MPR operates like a TDM Radio.
DS3's are collected, packetized, transmitted over the radio,
switched in the node and then de-packetized at the last node.
Grayed out for
TDM2TDM.
Grayed out for
TDM2TDM.
Apply settings
to all port
numbers.
9500-4018A
10/05/08