Changing Frequency; Software Upgrade Procedures; Upgrade From An Unprotected To A Protected Radio; 1+0 Static Modulation To 1+1 Hsb In Static Modulation - Alcatel-Lucent 9500 MPR User Manual

5.6

CHANGING FREQUENCY

Refer to the attached CD.
5.7

SOFTWARE UPGRADE PROCEDURES

Software Kit
Software Kit PN 3EM23502AAAA is delivered with each 9500 MPR. The soft-
ware kit consists of the following three CD ROMs:
• 9500MPR-A CT R01.01.00 - Craft Terminal (CT) software - hereafter called
WebEML (JUSM/CT) - installed on the PC at initial turnup
• 9500MPR-A SWP R01.01.00- radio application software - not required for ini-
tial turnup - hereafter called SWP
• v404 MIB - SNMP MIB software - not required for initial turnup - hereafter
called MIB
The SWP and MIB software is downloaded on the NE flash card and the flash
card is installed on the CSM at the factory. It is not necessary to install SWP
and MIB software on the PC at initial turnup. The SWP CD is supplied with the
equipment for backup. The MIB CD is supplied for use by third-party SNMP
applications.
Procedure
Refer to Software Upgrade Guide 3EM233201107RJZZA.
5.8

UPGRADE FROM AN UNPROTECTED TO A PROTECTED RADIO

5.8.1

1+0 Static Modulation to 1+1 HSB in Static Modulation

Starting from a NSB 1+0 configuration (see graphics below) perform the following proce-
dure to upgrade to a 1+1 HSB radio with Static Modulation.
This is an in-service but not a hitless procedure.
5-20
CAUTION
Possibility of
Service
Interruption