Alcatel-Lucent 9500 MPR User Manual page 90

Signal Mode .
Configures framing detector on
P32E1DS1 module.
Service Profile. Provisioning Rules:
1. DS1 Port Service Profile provisioning must be the same at
both ends of the link.
2. DS1 ports can be provisioned independently.
3. Provisioning a DS1 port TDM2TDM prevents cross-
connecting that DS1 port to Ethernet access ports 1-4.
4. Flow ID number is unique for that DS1 port and once
assigned, cannot be repeated throughout the network.
Figure 4 - 16 P32E1DS1 Module Provisioning TDM2ETH (Sheet 2 of 2)
4-38
Select:
•
Disabled – No alarm and no AIS insert
•
Unframed – Insert AIS on LOS (Tx & Rx)
•
Framed – Insert AIS on LOF and LOS (Tx & Rx)
Apply settings
for this port
number.
TDM2Eth
In TDM2Eth mode, all of the DS1's are collected, packetized and
made available over Ethernet at the last node.
In TDM2TDM mode, the MPR operates like a TDM Radio. DS1's
are collected, packetized, transmitted over the radio, switched in
the node and then depacketized at the last node.
Payload Size
Number of data bits
without overhed in Mb.
Select ADAPTIVE to sync TDM output
to packets. Select DIFFERENTIAL to
sync TDM output to NE Synchronization
source. Select TDM_Line_In to sync
TDM output to TDM input.
ECID (Emulation IDentification) is a network
unique 8-bit code identfier used along with V-Lan
to identify and switch individual DS1 lines through
the CSM.
• Unique network number
• Same ECID for same line at opposite end
• Entered only at terminating ends of line
(Tx/start and Rx/end, both directions)
• Not required for thru-repeaters
• Required for dropped and inserted lines at
drop and insert repeater
• Main and Spare the same in 1+1 configuration
• ECID and Flow ID for line can be the same
Apply settings
to all port
number
numbers.
9500-4013A
10/05/08