Software Load/License Key Upgrade; Software Installation; Getting Started - Alcatel-Lucent 9500 MPR User Manual

4.4.2

Software Load/License Key Upgrade

Refer to the Maintenance
4.5

SOFTWARE INSTALLATION

This section explains how to prepare the Craft Terminal application in your PC.
4.5.1

Getting Started

•
The operator must be familiar with the use of personal computers in WINDOWS envi-
ronment, internally from which the NE application software operates.
•
To properly install Craft Terminal application, a PC is required, having the character-
istics specified below.
PC Characteristics
The PC to use for Craft Terminal application must meet following characteristics:
PC HW Configuration:
• CPU: Pentium III 850 MHz
• RAM: 512 Mbytes (minimum), 1 Gbyte (suggested)
• Min. disk space: 1.5 Gbytes (available space needed, JRE excluded)
• Min. resolution: equal or higher than 1024x768 pixel
• CD-ROM Drive: 24x
• Primary Interface: Ethernet Card 10/100 Mbits/sec.
Operating Systems Supported:
• Microsoft Windows 32-bit versions: Microsoft Windows XP Professional Service
Pack 2
Additional requirements:
• Microsoft Internet Explorer 6.0 6.02900.2180 SP1+ or higher, Microsoft Internet
Explorer 7 7.0.5730.11CO + or higher
• Administrator or Power User rights
• Java Runtime Environment (JRE) 6 Update 3 (it is available on the CT CD-
ROM)
• Disable all Firewall software on PC used if possible. If a firewall must be used,
refer to Configuring Windows Firewall procedure on the attached CD.
section for software upgrades after initial turnup.
Note
Read the following before getting started.
4-3