Alcatel-Lucent 9500 MPR User Manual page 128

4.7.6.4 Cross Connecting RADIO (MD300 module) to RADIO (MD300 module)
The following procedure applies to switching data between two radios, such as a repeater.
See Figure 4 - 32.
Prerequisites:
• Both MD300 modules must be enabled on the respective MD300 module
provisioning screens.
When making a cross connection between two radio modules, use the
TDM2TDM service profile if the termination points of the circuit are
configured TDM2TDM.
Use the TDM2ETH service profile if the termination points of the cir-
cuit are configured TDM2ETH.
Use the TDM2ETH service profile when making the point-to-point
VLAN connection.
• The Service Profile on the P32E1DS1/P2E3DS3 module settings screen
must be set for each DS1/DS3 cross connected.
4-76
Figure 4 - 31 ETH-To-Radio Cross Connect
Note
9500-1136A
07/12/08