Initial Turnup; Section Introduction; Recommended Sequence; Security Management - Alcatel-Lucent 9500 MPR User Manual

The information contained in this section is a summary of the informa-
tion on the enclosed CD. "Refer to CD" is used throughout this section
to refer the reader to the detail information on the CD.
4

INITIAL TURNUP

4.1

SECTION INTRODUCTION

This section describes the procedures required to turn up the 9500 MPR Microwave
Packet Radios after installation.
This provisioning part of the section describes provisioning options available with the 9500
MPR software application. Provisioning allows for the definition, editing, and storing of
specific functions.
4.2

RECOMMENDED SEQUENCE

Perform the following initial turnup procedures in sequence:
A. Install software on PC (2 CDs).
Software installed at the factory before delivery should not be over-
written by downloading to the radio controller at initial turnup. Refer
to Maintenance section on the attached CD for procedure to upgrade
existing software.
B.
Turn on the radio.
C.
Establish communication between radio and PC.
Saving provisioning on disk provides a reference for any future provi-
sioning changes.
D. Provision radio and save to disk.
4.3

SECURITY MANAGEMENT

A password is required to operate the 9500 MPR. The radio is shipped
with a default password and if a new password is desired, it must be
entered using the Change Password screen. Once entered initially, the
password must be entered each time the user wants to access the NE.
Note
Note
Note
Note
4-1