Alcatel-Lucent 9500 MPR User Manual page 142

Equipment Alarm Description
CSM Card Fail
Equipment Mismatch
Card Missing
Unconfigured Equip-
ment
LOS on ETH TMN
Interface
PPP IP Fail
LOS on Gigabit ETH
Interface
Firmware Download
In Progress
LOS on Sync Interface
Degraded Signal on
Sync Interface
License Mismatch for
Equipment Provisioned
P32E1DS1 Card Fail
Module
Equipment Mismatch
Card Missing
Unconfigured Equip-
ment
LOS on PDH Tributary
5-4
Table 5-1 Alarm Matrix
1+1
1+0 1+FD
HS
Major Minor Minor
N/A Minor Minor
N/A Minor Minor
N/A Minor Minor
Minor Minor Minor
Minor Minor Minor
Major Major Major
Minor Minor Minor
Minor Minor Minor
Minor Minor Minor
Major Major Major
Major Minor Minor
Major Minor Minor
Major Minor Minor
Minor Minor Minor
Major Minor Minor
Most Probable
Action
Cause
Core module failed Replace Core module
Module in slot does Install correct config-
not match module ured module
configured in Core
memory
Core module is miss- Install Core module in
ing from slot. slot
Module in slot is not Provision module
provisioned
(enabled)
No Ethernet input Check link partner and
signal detected on cable between link
ETH 4 on Core mod- partner and ETH 4 con-
ule nector
Loss of Ethernet in Check link partner and
detected on ETH 1-4 cable between link
on Core module partner and ETH 1-4
connector
Status of download Wait for downloading
to complete
No sync clk detected Check sync source and
at Sync In port on cable between sync
Core module source and Sync In
port.
Sync clk errors Check sync source for
detected at Sync In errors
port on Core module
Wrong flash card Install correct flash card
installed on Core for license
module
Failure of Replace P32E1DS1
P32E1DS1 module module
Module in slot does Install correct config-
not match module ured module
configured in Core
memory
P32E1DS1 module Install P32E1DS1 mod-
is missing from slot. ule in slot.
Module is not Enable module
Enabled on the Set-
tings screen
No DS1 input sig- Check DS1 source and
nal detected on any or cable
one or more of 32
lines