Alcatel-Lucent 9500 MPR User Manual page 37

Power Emission Status LED.
Indicates output power status of ODU as follows:
• Off – No Output power (eg: Hot-Standby XMTR, software is
booting, or FPGA downloading is in progress
• Green – Normal output power
• Yellow – Forced squelch enabled on Craft Terminal
• Red – Abnormal output power (high or low limits exceeded)
IF To/From ODU
Module Status LED.
Indicates the status of the MD300 module as follows:
• Off – Module not equipped, not provisioned, or not
powered
• Green Blinking – Download, software booting, or flash
Module realignment in progress
• Green – In service, normal operation, and properly
provisioned
• Yellow – In standby, properly provisioned as EPS
• Red – Module fail
• Red Blinking – Card mismatch
Figure 2-7 MD300 Module Indicators and Connector
(QMA)
Power Emission Status
Module Status
9500-1028A
08/21/08
2-9