Moving The Processor Into Position - Kodak X-Omat 270 RA Installation Instructions Manual

Moving the Processor into Position

The weight of the PROCESSOR is 125 kg (275 lb).
[1] Unpack the STAND.
[2] Install the LEVELING SCREWS on the
STAND. See Figure 5.
[3] Remove the FRONT PANEL of the STAND.
[4] Place the PROCESSOR on the STAND.
[5] Insert each of the 4 MOUNTING BOLTS
through the STAND into the PROCESSOR
near the 4 corners.
[6] Tighten the 4 MOUNTING BOLTS.
STAND
8
Figure 5 Installing the Leveling Screws on the Stand
STAND
MOUNTING BOLT (4)
Figure 4 Installing the Processor on the Stand
PROCESSOR
FRONT
PANEL
H104_0544GCA
H104_0544GA
LEVELING
SCREW
H104_0224BCA
H104_0224BA
2B6843