Table of Contents
Advertisement
Special Tools Required
The following tools are required:
Tool or
Part No.
TL-1434
TL-2431
TL-4391
TL-4430
699574
* The Portable Computer should meet the following requirements:
MS-DOS version 3.3 or higher
RS-232 serial communication port configured as COM1
3.5-inch, 720 kilobyte disk drive
640 kilobyte RAM
20 megabyte hard disk
• Use only qualified personnel to install the PROCESSOR.
• Before installing the PROCESSOR, review the Section ''Electrostatic Discharge'' on page 4 to ensure
that components do not become damaged while you are installing the JUMPERS in the PROCESSOR.
• Hardware is provided to secure the WALL BRACKETS to the PROCESSOR. Hardware to secure the
BRACKETS to the wall is provided by the customer. Check that the hardware is available before
beginning the installation.
2B6843
Preliminary Items
Description
Portable Computer *
Level - approximately 30.5 cm (12 in.)
Air Meter
Interface Cable
PROM Extraction Tool
Diagnostics Diskette
IMPORTANT
3
Advertisement
Table of Contents
