Kodak X-Omat 270 RA Installation Instructions Manual page 13

The edge of the LEVEL could cause damage to the surface of a ROLLER.
[4] Place the LEVEL TL-1434 on the TIE RODS to level the PROCESSOR from side to side and front to
back.
LEVEL
Figure 12 Leveling the Processor Side to Side
To prevent damage to the LEVELING
SCREWS or to the PROCESSOR, do
not allow more than 2.5 cm (1 in.)
between the bottom of the STAND and
the HEAD of the LEVELING SCREW.
[5] Adjust the LEVELING SCREWS to level the
PROCESSOR in both directions.
[6] Install the BRACKETS to the PLYWOOD.
See Figure 7 on page 10.
2B6843
LEVEL
H104_0028ACA
H104_0028AA
Figure 13 Leveling the Processor Front to Back
LEVELING
SCREW
Figure 14 Adjusting the Leveling Screws
TIE RODS
HEAD
H104_0027ACA
H104_0027AA
H108_0036ACA
H108_0036AA
13