Table of Contents
Advertisement
[8]
Connect the wires from the power line to TB1. Check that the wires are connected firmly.
[9]
Connect wires 1 - 4 from the PROCESSOR to TB1.
[10]
Install the JUMPERS packed with the PROCESSOR to TB2 and TB3. See pages 19 - 20.
[11]
Connect the ground wire that is in the power line to the GROUNDING LUG.
[12]
Install the FEED END ACCESS PANEL.
[13]
Install the correct UL/CSA or VDE LABEL on the inside of the processing TANK, on the drive side.
STRAIN
RELIEF
H104_0119BCA
18
TB2
Figure 18 Connecting the Electrical Supply
drive
side
Figure 19 Applying the UL/CSA or VDE Label
TB3
KODAK
X-OMAT 270RA Processor
SERVICE
3059
CODE
200V-23 AMP 50/60Hz 3PH 3W 220V-23 AMP 50/60Hz 1PH 2W
230V-23 AMP 50/60Hz 1PH 2W 240V-23 AMP 50/60Hz 1PH 2W
100/200V-23 AMP 50/60Hz 1PH 3W 120/240V-23 AMP 60Hz 1PH 3W
120/208V-24 AMP 60Hz 3PH 4W 127/220V-23 AMP 50Hz 3PH 4W
220/380V-12 AMP 50Hz 3PH 4W 230/400V0-13 AMP 50Hz 3PH 4W
240/415V-13 AMP 50Hz 3PH 4W
apply
LISTED
115B
label
here
Made in USA by
Eastman Kodak Company
Rochester, New York 14650
TB1
GROUNDING
LUG
H104_0119BA
SERIAL
NUMBER
H104_0546BCA
H104_0546BA
2B6843
Advertisement
Table of Contents
