Table of Contents
Advertisement
Installing the Silver Recovery Units
If the customer is using a Kodak Chemical Recovery Cartridge Model II or the Junior Model II, install it now. If
the PROCESSOR is without a STAND, only the Junior Model II can be used. A PROCESSOR connection kit
for recirculating silver recovery units may be needed.
When installing the kit, use the installation instructions packed with the kit.
Connecting the Drains and the Exhaust Hose
• Drains must be made of chemically resistant, non-corrosive material. Use PVC or the
equivalent. Do not use copper or brass.
• The drain must have a minimum diameter of 7.6 cm (3 in.) and be free of obstruction.
• Drain service must comply with all local codes.
• Do not make a solid connection between the hoses and the drain.
• The drain line should slope gradually downward to the floor drain.
[1]
Check that the DEVELOPER and FIXER DRAIN are closed.
Any restriction such as a kinked or upward sloping hose from the WASH DRAIN can cause the
draining wash water to move back into the WASH TANK. This can cause an overflow of water
onto the ELECTRICAL BOX. Correctly route the hose so that it slopes toward the floor drain.
REINFORCED HOSE, which will not kink, and right-angle ELBOWS for entering the drain are
available from Service Parts Management. Order the following parts, if necessary:
• 696442 - Reinforced Hose, 5/8 in. ID, order by the foot
• 1C4521 - Elbow, 5/8 in.
• 696441 - Reinforced Hose, 1 in. ID, order by the foot
• 1C4524 - Elbow, 1 in.
[2]
Connect the following to the floor drain and route the hoses as required.
• DEVELOPER OVERFLOW
• DEVELOPER DRAIN
• FIXER DRAIN
• FIXER OVERFLOW to the floor drain or the CHEMICAL RECOVERY CARTRIDGE if used
• WASH OVERFLOW/DRAIN
[3]
Connect the EXHAUST HOSE to the AIR EXHAUST on the PROCESSOR.
[4]
Check the negative Static Pressure. See the Venting procedure in the Site Specifications, Publication
Part No. 2B6842.
28
NOTE
IMPORTANT
2B6843
Advertisement
Table of Contents
