Table of Contents
Advertisement
[9]
Remove the DEVELOPER MANDREL.
[10]
Remove the WING NUT from the
DEVELOPER MANDREL.
[11]
Install:
• DEVELOPER FILTER onto the
DEVELOPER MANDREL
• WING NUT
• DEVELOPER MANDREL in the
DEVELOPER TANK
[12]
Check that the DEVELOPER MANDREL is
correctly seated.
[13]
Install the external PANELS.
[14]
Close the TOP COVER.
[15]
Allow approximately 15 minutes for the
''Ready'' light on the DISPLAY PANEL to
illuminate.
[16]
Check that the correct developer temperature
is displayed on the DISPLAY PANEL. See
the Operator Manual, Publication Part
No. 2B6841, for the procedure to determine
that the temperature displayed is correct.
[17]
Feed several sheets of processed film into
the PROCESSOR, and check that the
TRANSPORT SYSTEM operates correctly.
[18]
Move CIRCUIT BREAKER CB1 to the ''O''
position.
[19]
Drain the TANKS of water.
[20]
Mix the chemicals and fill the processing
TANKS. See the Operator Manual,
Publication Part No. 2B6841.
3059II_S.txt
32
DEVELOPER
MANDREL
DEVELOPER
FILTER
WING
NUT
Figure 27 Installing the Filter on
the Developer Mandrel
H104_0029ACA
H104_0029AA
DISPLAY
PANEL
H104_0107ACB
H104_0107AA
2B6843
Advertisement
Table of Contents
