Standard Operator Option Code; Programming Using The Cf Switches - Hyundai hirun N100 plus Instruction Manual

plus
N100 INSTRUCTION MANUAL

Standard operator option code

Set the parameter [
Terminal
Option
Symbol
Code
Valid for inputs:
Required setting
Notes:
When programming the multi-speed
setting sure to press the Store key each
time and then set the next multi-speed
setting. Note that when the key is not
pressed, no data will be set.
When a multi-speed setting more
than 50Hz(60Hz) is to be set, it is
necessary to program the maximum
frequency A04 high enough to allow
that speed.
While using the multi-speed capability, you can monitor the current frequency
with monitor function
There are two ways to program the speeds into the registers
Programming using the CF switches, Set the speed by following these steps
(1) Turn the Run command off(Stop Mode).
(2) Turn each switch on and set it to Multi-speed n. Display the data section
of .
F 01
(3) Set an optional output frequency by pressing the
(4) Press the
STR
indicates the output frequency of Multi-speed n.
F 01
(5) Press the
FUNC
frequency.
(6) When you repeat operations in (1) to (4), the frequency of Multi-speed can
be set. It can be set also be parameters
C 01
Function Name
C01,C02,C03,C04,C05,C06
F01, A11 to A25
during each segment of a multispeed operation.
F 01
key once to store the set frequency. When this occurs,
key once to confirm that the indication is the same as the set
] to [
C 06 0 2
State
Example:
CF4 CF3 CF2 CF1 FW
6 5
CM1
SW6 SW5 SW4 SW3 SW2 SW1
to
A 25
A 11
]
0 5
Description
4 3 2 1
to
A 20
and keys.
P24
A 25