Installing The Internal Vpn/Ipsec Module; Prerequisites - Nortel Secure Router 4134 Installation — Hardware Components

If you ordered the VPN/IPSec module with your Secure Router 4134, the
Secure Router ships with the VPN/IPSec module installed.
Average time to install the internal VPN/IPSec module: 2 minutes.

Installing the internal VPN/IPSec module

Use the procedure in this section to install an internal VPN/IPSec module.
If you are replacing a VPN/IPSec module, also see
VPN/IPSec module" (page

Prerequisites

•
•
•
Procedure steps
Step
1
2
3
4
Copyright © 2007, 2008 Nortel Networks
.
Installing or removing the internal VPN/IPSec module 73
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Ensure you have a VPN/IPSec module ready to install before opening
the service access panel.
Ensure you have a Phillips #2 screwdriver.
Ensure the Secure Router 4134 has the power switched off.
Action
Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. Remove these two
screws only. See the following figure.
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Locate the internal VPN/IPSec module connector slot.
Holding the VPN/IPSec module by its edges, align the connector
with the slot on the Main Board, pushing down gently, but firmly,
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
74).
"Removing the internal