Nortel Secure Router 4134 Installation — Hardware Components page 64

64 Installing Secure Router 4134 hardware components
•
Procedure steps
Step
1
2
3
4
5
6
7
8
9
Copyright © 2007, 2008 Nortel Networks
.
uses the last saved configuration. To save your configuration, enter
save local.
Ensure you have the replacement interface module ready to install.
Action
To verify that the Secure Router 4134 recognizes the interface
module, enter:
show chassis
Proceed with the hot swap of the interface module if, and only if,
the interface module appears in the list of installed modules on
the Secure Router 4134. If the interface module does not appear
in the list of installed modules, see Nortel Secure Router 4134 —
Troubleshooting (NN47263-700).
To access the configuration mode, enter:
configure terminal
To select the interface module you want to shutdown, enter:
chassis module <slot>
Do not enter a port number.
To shut down the interface module, enter:
shutdown
It can take longer for the Mediation Server Module to shut down
compared to other modules because the Mediation Server
Module must wait for the Windows Server 2003 operating system
to shut down properly.
To verify the change in status of the module, enter:
show chassis
Remove the interface module from the Secure Router 4134.
Move the cables from the module you removed to the
replacement module.
You must connect each cable in the same port on the
replacement module that the cable occupied in the module you
removed.
Insert the replacement interface module in the slot, securing it
firmly with the captive screws. Ensure you are in configuration
mode, then enter the following command to select the
replacement module:
chassis module <slot>
Enter the following command to set the replacement module to
an active state:
no shutdown
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008