Prerequisites; Installing Or Replacing A Power Supply Module - Nortel Secure Router 4134 Installation — Hardware Components

70 Installing Secure Router 4134 hardware components
Average time to connect the console port cable to a local terminal: 1
minute.

Prerequisites

•
•
•
Procedure steps
Step
1
2
3

Installing or replacing a power supply module

The Secure Router 4134 operates with one or two AC power supply
modules, one or two DC power supply modules, or one AC and one DC
power supply module. You install the power supply modules at the rear of
the unit.
Average time to install or replace one power supply module: 1 minute.
Copyright © 2007, 2008 Nortel Networks
.
Ensure you have the supplied console cable ready to install.
Ensure you have the supplied female DB-9 to RJ-45 adapter if you
require it for connection to your terminal or PC.
Ensure you have the Secure Router 4134 securely installed in the
equipment rack.
Action
Insert the male RJ-45 connector in the console port on the rear
panel of the Secure Router 4134.
Connect the female DB-9 to RJ-45 adapter to the opposite end
of the console cable, if necessary.
Insert the RJ-45 or female DB-9 connector (dependent on your
equipment) in a terminal or PC.
CAUTION
Risk of equipment damage
Watch the power supply status LED for alerts if you hot swap
a power supply module.
CAUTION
ESD
To prevent damage from electrostatic discharge, always
wear an antistatic wrist strap connected to an ESD jack when
performing maintenance on a Secure Router 4134. Ensure that
the wrist strap makes contact with your skin.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
--End--