Installing A Large Module - Nortel Secure Router 4134 Installation — Hardware Components

6

Installing a Large Module

Install the Large Module in slots 6–7 only.
Procedure steps
Step
1
2
3
4
5
6
7
Copyright © 2007, 2008 Nortel Networks
.
Using a Phillips screwdriver, tighten the two captive screws to
secure the module to the chassis.
Action
Using a Phillips screwdriver #2, remove the slot cover plates
from slots 6 and 7.
Loosen the captive screw at the top of the center slot module
guide.
Remove the center slot module guide. The following figure
shows the removal of the center slot guide.
Align the Large Module with the slot and the slot module guides
on the outside edges of the slot.
Slide the module into the chassis until its connector panel
touches the chassis back panel.
Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
Ensure the levers on the module are flush with the front panel of
the Secure Router 4134.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
Installing the interface modules 61
--End--