Installing Or Removing An Internal Pvm - Nortel Secure Router 4134 Installation — Hardware Components

76 Installing Secure Router 4134 hardware components
4
5

Installing or removing an internal PVM

Use the instructions in this section to install, remove, or replace the
internal Packetized Voice Module (PVM). This internal module is not
hot-swappable.
ATTENTION
You cannot enable the management port on the rear of the Secure Router 4134
(Ethernet 0/0) if you have a PVM installed (this is related to hardware design).
Ensure you use Ethernet 0/1, 0/2, 0/3, or 0/4 for management if you use a PVM
in the router.
If you ordered the PVM with your Secure Router 4134, the Secure Router
ships with the PVM installed.
Copyright © 2007, 2008 Nortel Networks
.
Grasping the edges of the VPN/IPSec module, pull the module
up and out of the slot in which it is seated.
If you are not installing a VPN/IPSec module at this time, replace
the service access panel.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
--End--