Installing Or Removing The Dimm On The Mediation Server Module For Ocs - Nortel Secure Router 4134 Installation — Hardware Components

84 Installing Secure Router 4134 hardware components
5
6
Installing or removing the DIMM on the Mediation Server Module
for OCS
Use the instructions in this section if you must install, remove, or replace
a DIMM on the Mediation Server Module for OCS. The DIMM on the
Mediation Server Module is not hot-swappable.
Average time to replace a DIMM on the Mediation Server Module: 4
minutes.
Copyright © 2007, 2008 Nortel Networks
.
Firmly grasp the DIMM by its edges and pull straight up to
remove the DIMM from the slot.
Insert the replacement DIMM in the slot, pushing down firmly but
gently to fully seat the DIMM in the slot.
The release latches close when the DIMM is properly installed.
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
--End--