Removing The Internal Vpn/Ipsec Module - Nortel Secure Router 4134 Installation — Hardware Components

74 Installing Secure Router 4134 hardware components
5

Removing the internal VPN/IPSec module

Use the procedure in this section to remove a VPN/IPSec module from the
Secure Router 4134.
Copyright © 2007, 2008 Nortel Networks
.
to seat the module.
The following figure shows the location for installing the
VPN/IPSec module.
Using a Phillips screwdriver, tighten the two screws that secure
the module to the Main Board.
CAUTION
The internal VPN/IPSec module is not hot swappable. Do not
open the Secure Router 4134 service access panel while the
unit is powered.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
--End--