Prerequisites - Nortel Secure Router 4134 Installation — Hardware Components

ATTENTION
The internal Compact Flash that ships with the Secure Router 4134 contains
the system image.

Prerequisites

•
•
Procedure steps
Step
1
2
3
4
Copyright © 2007, 2008 Nortel Networks
.
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Ensure you have a replacement Compact Flash ready to install.
Ensure you have a Phillips #2 screwdriver.
Action
Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. The following figure
shows the two screws that you must remove.
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Locate the internal Compact Flash module.
Firmly grasp the Compact Flash by its edges and pull straight up
to remove it from the slot. See the following figure.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
Replacing the internal Compact Flash 89