Installing A Medium Module - Nortel Secure Router 4134 Installation — Hardware Components

60 Installing Secure Router 4134 hardware components
Nortel recommends that you power down the Secure Router 4134 if you
are installing an interface module in a slot in which you have not previously
installed that module type.
If you are working with 2- or 4-port FXS or FXO Small Modules, ensure
you read the safety messages related to the FXS and FXO interface
modules. See
15)
Procedure steps
Step
1
2
3
4
5

Installing a Medium Module

Use the instructions in this section to install Medium Modules.
Procedure steps
Step
1
2
3
4
5
Copyright © 2007, 2008 Nortel Networks
.
"Foreign Exchange Station (FXS) Interface Modules" (page
and "Foreign Exchange Office (FXO) Interface Modules" (page
Action
Using a Phillips screwdriver #2, remove the slot cover plate from
the slot in which you are installing the module.
Align the module with the slot and the slot module guides.
Slide the module into the chassis until its connector panel
touches the chassis back panel.
Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
Using a Phillips screwdriver, tighten the two captive screws to
secure the module to the chassis.
Action
Using a Phillips screwdriver #2, remove the slot cover plate from
the slot in which you are installing the module.
Align the module with the slot and the slot module guides.
Slide the module into the chassis until its connector panel
touches the chassis back panel.
Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
Ensure the lever on the module is flush with the front panel of
the Secure Router 4134.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
--End--
16).