Installing The Internal Pvm - Nortel Secure Router 4134 Installation — Hardware Components

Average time to replace the internal PVM module: 2 minutes.

Installing the internal PVM

Use the procedure in this section to install an internal PVM. If you are
replacing a PVM, also see
Average time to install the internal PVM module: 1 minute.
Prerequisites
•
•
•
Procedure steps
Step
1
2
3
Copyright © 2007, 2008 Nortel Networks
.
CAUTION
Do not open the Secure Router 4134 service access panel while
the unit is powered.
Ensure the Secure Router 4134 has the power switched off.
Ensure you have a PVM ready to install before opening the service
access panel.
Ensure you have a Phillips #2 screwdriver.
Action
Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. Remove these two
screws only. See the following figure.
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Locate the internal PVM connector slot. The following figure
shows the location for installing the PVM.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
Installing or removing an internal PVM 77
"Removing the internal PVM" (page 80).