Nortel Secure Router 4134 Installation — Hardware Components page 86

86 Installing Secure Router 4134 hardware components
3
4
5
6
7
8
9
10
Copyright © 2007, 2008 Nortel Networks
.
Support the module as you remove it from the chassis by
grasping it by the edges.
Ensure you place the Mediation Server Module on antistatic
material if you lay it down to install a DIMM.
Always hold the module by its edges.
Locate the DIMM slot on the module.
The following figure shows the DIMM slots.
If the release latches on each end of the DIMM slot are engaged,
release the latches by pushing each latch away from the DIMM
slot.
Insert the DIMM in the slot, pushing down firmly but gently to
fully seat the DIMM in the slot.
The release latches close when the DIMM is properly installed.
Replace the Mediation Server Module in the chassis slot by
aligning the module with the slot module guides.
Slide the module into the chassis until its connector panel
touches the chassis back panel.
Push gently, but firmly, to seat the connector on the interface
module in the chassis back panel.
Ensure the lever on the module is flush with the front panel of
the Secure Router 4134.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008