Process Map For Installing And Configuring An Srg50 - Nortel SRG50 Configuration Manual

Process map for installing and configuring an SRG50

Figure 3 Process map for installing and configuring an SRG50
The main office is installed and running and the
information to support SRG50 has been configured.
You have reviewed the SRG50 and BCM50
system requirements and documentation.
Locate the BCM50 that will be
converted to the SRG50.
Install the physical components,
including expansion units, media bay
modules, cabling, telephones, and
peripherals, as per the BCM50
Installation & Maintenance Guide
Configure the basic parameters of the
BCM50 as per the BCM50 First Time
Installation and Configuration Guide
(N0027149). (Refer to the BCM50
Installation & Maintenance Guide
(N0027152) and the BCM50
Administration Guide (N0016868) as
required for detailed instructions).
Create the SRG50 as per the
Survivable Remote Gateway 50
Configuration Guide.
Complete the initial installation,
connect the SRG50 to the LAN (as
required) and WAN (to main office),
and test the SRG50 system, as per
the BCM50 Installation &
Maintenance Guide (N0027152).
Set up SRG50 administration, and
carry out non-SRG-specific
networking and device configuration
as per the BCM50 Administration
Guide (N0016868), the BCM50
Networking Configuration Guide
(N0027156), and the BCM50 Device
Configuration Guide (N0027146).
Chapter 1 Getting started
Install and configure attached
devices, as per the IP telephone and
analog device installation and
configuration guides, as required.
(Refer to "Setting up IP telephones"
on page 63
telephones. Refer to
for PSTN access and analog
devices" on page 91
analog trunks and devices.)
Set up the IP telephones for SRG
operation, as per
telephones" on page
Set up the private VoIP network, as
per "Setting up the private VoIP
network" on page
Configure the server-specific data for
the applicable main office call server.
Refer to the server-specific chapters
("CS 1000 considerations" on page
33 and "CS 2000 considerations" on
page 53).
Register each telephone
with the main office and the
SRG50.
Troubleshoot any registration issues
("Troubleshooting" on page
Test the telephones and analog
equipment in normal mode.
Familiarize users with the services for
local mode.
Survivable Remote Gateway 50 Configuration Guide
when configuring the IP
"Considerations
when setting up
"Setting up IP
63.
75.
95).
("" on page 101)
21