Nortel Secure Router 4134 Installation — Hardware Components page 81

Prerequisites
•
•
•
Procedure steps
Step
1
2
3
4
Copyright © 2007, 2008 Nortel Networks
.
Ensure the Secure Router 4134 has the power switched off.
Ensure you have a Phillips #2 screwdriver.
Ensure you have an antistatic bag or sheet available for the PVM that
you are removing.
Action
Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. Remove these two
screws only. See the following figure.
Slide the access panel toward you until it is clear of the Secure
Router 4134.
Locate the PVM.
Release the latches that secure the PVM in the slot. There is a
release latch at both ends of the PVM slot. See the following
figure.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
Installing or removing an internal PVM 81