Installing A Dimm On The Mediation Server Module - Nortel Secure Router 4134 Installation — Hardware Components

Installing a DIMM on the Mediation Server Module

Use the procedure in this section if you must install a DIMM on the
Mediation Server Module.
Average time to install a DIMM on the Mediation Server Module: 3
minutes.
Prerequisites
•
•
•
•
Procedure steps
Step
1
2
Copyright © 2007, 2008 Nortel Networks
.
Installing or removing the DIMM on the Mediation Server Module for OCS 85
CAUTION
To prevent damage from electrostatic discharge, always wear
an antistatic wrist strap connected to an electrostatic discharge
(ESD) jack when performing maintenance on this product.
Ensure that the wrist strap makes contact with your skin.
Ensure the Secure Router 4134 is powered down.
Ensure you have a Phillips #2 screwdriver.
Ensure you have antistatic material available on which to lay the
Mediation Server Module while you work.
Ensure you have a DIMM ready to install before opening the service
access panel.
Action
Using a Phillips screwdriver, loosen the two captive screws
that secure the Mediation Server Module to the chassis. The
following figure shows the screws.
Using the lever on the module, pull the module straight out of the
chassis slot.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008