Prerequisites - Nortel Secure Router 4134 Installation — Hardware Components

Prerequisites

•
•
•
Procedure steps
Step
1
2
3
4
Copyright © 2007, 2008 Nortel Networks
.
Ensure the Secure Router 4134 is powered down.
Ensure you have a replacement DIMM.
Ensure you have a Phillips #2 screwdriver.
Action
Remove the two screws at the rear of the Secure Router 4134
that hold the service access panel secure. The following figure
shows the two screws that you must remove.
Slowly slide the access panel toward you until it is clear of the
Secure Router 4134.
Locate the DIMM module.
Release the latches that secure the DIMM in the slot.
There is a release latch at both ends of the DIMM slot. See the
following figure.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301 02.01 Standard
18 February 2008
Replacing the DIMM in the Secure Router 4134 83