Speeddome Lt Auto Pan Programming - American Dynamics ADTT16E Operator's Manual

SpeedDome LT Auto Pan Programming

The Auto Pan is a special feature supported by SpeedDome LT only. It allows you program
a smooth side-to-side camera pan of an area. The SpeedDome LT does not allow you to
program the same types of Patterns that other domes support. Instead, use Pattern
programming to set the Auto Pan function.
Auto Pan Programming Limitations
Keep the following limitations in mind when programming the SpeedDome LT Auto Pan
feature:
Although it appears to have three Patterns available to program, you can only program the
•
Auto Pan feature for Pattern 1.
Any extraneous movements made during the Auto Pan programming will be ignored
•
when the programming is complete. Once the ending point of the Auto Pan is set, the
result will be a smooth pan between the start and end of the Auto Pan.
Do not attempt to create an Auto Pan that is greater than one revolution (360º) of the
•
SpeedDome LT. The dome will accept this pattern during programming; however, it will
not work when you attempt to run the pattern. The starting point and the ending point
must be less than one revolution of the SpeedDome for the Auto Pan to work properly.
If you attempt to program Pattern 2 or 3 for the dome, the system will take you through
•
the motions of the programming. However, the new Auto Pan will not be saved. Do not
attempt to program more than one Auto Pan per SpeedDome LT.
If you need to re-program the Auto Pan for the dome, you must select Pattern 1. Selecting
•
another available Pattern number will not change the previously programmed Auto Pan.
Programming Controller Functions 4-11