Running Patterns - American Dynamics ADTT16E Operator's Manual

Running Patterns

A Pattern is a sequential series of pan, tilt, zoom, and focus movements from a single
camera. You "teach" the camera a combination of these movements. Whenever the Pattern is
run, the camera automatically recalls the movements it was taught. Patterns can be run once
or run repeatedly until manually stopped. Most programmable domes support up to three
Patterns defined for it. The SpeedDome LT will support programming the Auto Pan feature
for Pattern 1; it does not support programming any additional patterns. Figure 3-11 illustrates
the locations of the Pattern and Repeat Pattern buttons.
Figure 3-11: Pattern and Repeat Pattern buttons
Menu
Chapter 4 provides Pattern programming instructions. If a list has been compiled for your
facility, refer to the Programming Worksheets (8200-0306-04) to determine which Patterns
are available for the installed domes.
Operating the ADTT16E Advanced Dome Controller
I M P O R T A N T
The SpeedDome LT supports a feature called "Auto Pan" that allows you to
program a smooth side-to-side camera movement for an area. See Chapter 4
for additional information.
A
B
Peel
1
Info
5
4
On
Output
Off
7 8
Clear
0
Iris
Open
Close
C
D
Flip
3
View
6
Pattern
Repeat
Pattern
9
Previous Next
Enter Pattern number
and press to run the
Pattern one time.
Enter Pattern number
and press to run the
Pattern continuously.
3-13