American Dynamics ADTT16E Operator's Manual page 37

The Primary Controller operator maintains control over the camera until one of the following
events occurs:
A different camera is selected
•
Menu/programming mode is started
•
The Controller Sequence is initiated
•
An alarm comes into the system
•
The selected camera remains idle for 3 minutes
•
Once the Primary Controller operator relinquishes control of a camera, the message,
Camera Free appears on the Secondary Controller (if the Call operator has that camera
selected).
Stepping Through the Cameras
Press the Previous and Next buttons to step backward and forward through all of the
cameras configured for your system. The video displays full-screen on the Main or Call
monitor depending upon the controller currently being used. Figure 3-3 illustrates the
locations of the Previous and Next buttons.
Figure 3-3: Previous and Next buttons
Note:
cameras are installed, the camera number must be manually entered.
Operating the ADTT16E Advanced Dome Controller
A
B
Peel
Info
On
Output
Off
Menu
Clear
Iris
Open
Close
Press to display previous
camera in series.
Previous and Next step through the first 16 cameras. If more than 16
Flip
1 3
View
5
4 6
Pattern
Repeat
Pattern
7 8 9
0
Previous Next
C
D
Press to display next
camera in series.
3-7