Speeddome Peel And Flip Features - American Dynamics ADTT16E Operator's Manual

SpeedDome Peel and Flip Features

The SpeedDome series camera domes support two special features called Apple Peel and
Flip. Pressing the appropriate buttons on the controller automatically activate these features.
Figure 3-8 illustrates the location of the Peel and Flip buttons.
Figure 3-8: Peel and Flip buttons
Press to run the
default SpeedDome
pattern.
Running the "Apple Peel" Pattern
The Apple Peel pattern consists of three revolutions of camera panning (with tilt) starting at
the ceiling line. Each revolution tilts down approximately 30°. The Apple Peel pattern
provides you with a complete view of the area. Figure 3-9 illustrates the Apple Peel pattern
movement.
Figure 3-9: Apple Peel Pattern
Select the camera and press Peel to run the Apple Peel pattern. The Apple Peel pattern
repeats indefinitely until a camera command (pan, tilt, zoom, focus, or iris) is issued to the
camera. The following message displays on the LCD while the Apple Peel pattern is
running:
Operating the ADTT16E Advanced Dome Controller
A
B
Peel
Info
On
Output
Off
Menu
Clear
Iris
Open
Close
Note:
If the ADTT16E controller is used with a Sensornet-to-RS-422 Code
Converter and Pattern 3 has been programmed, pressing Peel runs Pattern 3.
Flip
1 3
View
5 6
4
Pattern
Repeat
Pattern
7 8 9
0
Previous
Next
Cam 16
Apple Peel Patn
C
D
Press to rotate the
SpeedDome 180°
+
3-11