Running The Controller Sequence - American Dynamics ADTT16E Operator's Manual

Running the Controller Sequence

The Controller Sequence consists of a collection of 16 events (Quick Views, Patterns, and
fixed shots) from the system cameras. When the Sequence is running, these events are
automatically displayed one after the other on the Main monitor. Each event remains on the
monitor for a specified duration (from 1 to 90 seconds); each event may have a different
duration.
Chapter 4 provides instructions for programming the Controller Sequence. Use to the
Programming Worksheets (8200-0306-04) to list Quick Views and Patterns to include in
the Controller Sequence.
Press the Seq button on the Primary Controller to run the Controller Sequence. Figure 3-12
illustrates the location of the Sequence button. Figure 3-13 illustrates the information
appearing on the LCD when the Controller Sequence is running.
Figure 3-12: Sequence button
Menu
Figure 3-13: Sequence LCD display information
The Sequence repeats indefinitely until Seq or Clear is pressed on the Primary Controller.
Operating the ADTT16E Advanced Dome Controller
Tip:
Only the Primary Controller can be used to perform this task.
A
B
Peel
1
Info
4 5
On
Output
Off
7 8
Clear
0
Iris
Close Open
Camera number of the
currently running event
C
D
Flip
3
View
6
Pattern
Repeat
Pattern
9
Previous Next
Cam 3 6
Sequencing 12
Seconds remaining
until the next Sequence
event
Press to start the
Controller Sequence.
(Primary Controller only)
Current Sequence event
number
3-15