Auto Pan Programming Instructions
1. Select the camera requiring alarm programming.
2. Adjust the pan, tilt, zoom and focus settings for the camera until the starting point for the
Pattern appears on the monitor.
3. Press Menu.
4. Scroll through the menu until Record Pattern appears on the LCD. Press Zoom or
Focus to select.
5. Enter Patrn#? appears on the LCD. Press number 1.
6. Move the camera until you see ending point for the Auto Pan you are programming.
I M P O R T A N T !
This ending point must be less than one full revolution of the dome.
7. Press Next when finished programming. Pattern Saved appears briefly on the LCD.
The controller automatically returns to camera control mode after saving the Pattern. Make a
record of the Pattern, including the camera number and a brief description in the
Programming Worksheets (8200-0306-04).
4-12
ADTT16E Advanced Dome Controller Operator's Manual