Solving Problems - American Dynamics ADTT16E Operator's Manual

Changing the Alarm Acknowledgement Setting
Tip:
The controller is initially set to acknowledge alarms automatically after a 60-second delay.
The setting can be changed to manual alarm acknowledgement.
1. Press Menu.
2. Scroll through the menu items until Tog Alarm ACK appears on the LCD.
Press Zoom or Focus to select.
The current alarm acknowledgement setting appears on the LCD.
Auto-Ack Alarm
Change w <Next>
3. Press Next to change the setting.
Auto-Ack Alarm appears on the LCD if automatic acknowledgement is enabled.
•
Manual-Ack Alarm appears on the LCD if automatic acknowledgement is
•
disabled.
4. Press Menu to save the changes and return to camera control mode.
I M P O R T A N T
Alarms can be manually acknowledged when automatic alarm acknowledgement
is enabled. Press Clear whenever alarms occur.
Displaying System Information
This procedure allows you to display system information about the ADTT16E advanced
dome controller.
1. Press Menu.
2. Scroll through the menu items until Show System Info appears on the LCD. Press
Zoom or Focus. The current controller setting appears on the LCD.
The following system information is available:
Controller Type: Primary or Secondary Unit
•
ROM Checksum Values
•
Calibration information (display should read all 0)
•
Product Code Flash Version
•
Product Code EEPROM Version
•
3. Press Previous or Next to display the information.
4. When finished reviewing the information, press Menu to return to camera control mode.
Using System Utilities and Solving Problems
Only the Primary Controller can be used to perform this task.
Manual-Ack Alarm
Change w <Next>
6-9