American Dynamics ADTT16E Operator's Manual page 71

Displaying Dome Identification Information
1. Select the dome whose information you need to display.
2. Press Menu.
3. Scroll through the menu items until Show Dome Info appears on the LCD.
Press Zoom or Focus to select.
4. The dome's Flash PROM and EEPROM information appear on the LCD:
Flash PROM Version
5. When finished viewing the dome information, press Menu to resume camera control
mode.
Resetting a Dome
Reset the dome if it stops responding to controller commands.
1. Select the dome that has stopped responding to commands.
2. Press Menu.
3. Scroll through the menu items until Reset Dome appears on the LCD. Press Zoom or
Focus to select.
4. The LCD displays the selected camera number and Reset In Process.
Note: The dome cannot be operated while resetting. Once the reset completes, the controller
returns to the camera control mode.
Adjusting Camera V-Phase
I M P O R T A N T
Using the V-Phase utility on off-line domes or fixed cameras generates a
warning beep and disallows use of the utility. For additional information on
adjusting the V-Phase, see the service manual.
Only authorized service personnel should perform this function!
To adjust the V-phase of a selected camera:
1. Press Menu.
2. Scroll through the menu items until Adjust V-Phase appears on the LCD.
Press Zoom or Focus to select.
3. Press Next or Previous to observe the V-Phase through the oscilloscope or Fluke
scope.
4. When the V-Phase setting is acceptable, press Menu to exit.
Using System Utilities and Solving Problems
F 0701-0147-0101
E 0701-0248-0101
EEPROM Version
6-3