Controlling Dome Outputs - American Dynamics ADTT16E Operator's Manual

Controlling Dome Outputs

Output devices are hardware components connected to dome outputs that can be operated by
the controller. Typical output devices include gates, door strikes, and lights. Depending upon
the dome type, as many as four output devices may be connected. The output control
buttons on the controller activate or deactivate the output devices connected to the
currently selected dome. Figure 3-14 illustrates the location of these buttons.
Figure 3-14: Output control buttons
Press to activate the
selected dome
output.
Press to deactivate
the selected dome
output.
The following procedure describes how to activate or deactivate a dome output. You must
know the dome number and the output number before performing this procedure.
1. Select the camera whose output state you want to control.
2. Enter the output number, and press an output control button.
Action
Press Output On to activate
Press Output Off to deactivate
The controller beeps if an invalid output number or non-existent output number is
entered.
Tip:
of the Inputs / Outputs Worksheet found in the Programming Worksheets
(8200-0306-04) next to the controllers to help operators determine which
outputs are available.
3-16
Up to 64 output devices can be configured at a single facility. Post a copy
A
B
Peel
Info
On
Output
Off
Menu
Clear
Iris
Close
LCD Information
Cam 13 +
Output On
Cam 13 +
Output Off
ADTT16E Advanced Dome Controller Operator's Manual
1 3
4 5 6
7 8 9
0
Open Previous
C
D
Flip
View
Pattern
Repeat
Pattern
Next