Visualdsp++ Install And Session Startup - Analog Devices ADSP-21479 EZ-Board Manual

VisualDSP++ Install and Session Startup

For information about VisualDSP++ and to download the software, go to
www.analog.com/VisualDSP
There are two options to connect the EZ-Board hardware to a personal
computer (PC) running VisualDSP++: via an Analog Devices emulator or
via a standalone debug agent module. The standalone debug agent allows
a debug agent to interface to the ADSP-21479 EZ-Board. The standalone
debug agent is shipped with the kit.
To connect the EZ-Board to a PC via an emulator:
1. Plug the 5V adaptor into connector
2. Attach the emulator header to connector
back side of the EZ-Board.
To connect the EZ-Board to a PC via a standalone debug agent:

The debug agent can be used only when power is supplied from the
wall adaptor.
1. Attach the standalone debug agent to connectors
and
ZP1
pin of
P1
2. Plug the 5V adaptor into connector
3. Plug one side of the provided USB cable into a USB connector of
the standalone debug agent. Plug the other side of the cable into
a USB port of the PC running VisualDSP++.
4. Verify that the yellow USB monitor LED on the standalone debug
agent (
LED4
fies that the board is communicating properly with the host PC
and ready to run VisualDSP++.
ADSP-21479 EZ-Board Evaluation System Manual
.
on the backside of the EZ-Board, watching for the keying
to connect correctly.
, located on the back side of the board) is lit. This signi-
Using The ADSP-21479 EZ-Board
(labeled
P5
(labeled
P1
(labeled
P5
).
5.0V
) on the
JTAG
(labeled )
P1 JTAG
).
5.0V
1-9