Table of Contents
Advertisement
Connectors
VDDEXT Power Connector (P6)
The
power connector (
VDDEXT
voltage and current. By default,
two-pin IDC header. To measure power, remove the jumper on
measure voltage across the 0.1 ohm resistor. Once voltage is measured,
power can be calculated. For more information, refer to
ments" on page
VDDINT Power Connector (P7)
The
power connector (
VDDINT
supplied to the processor core. By default,
through the two-pin IDC header. To measure power, remove the jumper
on
and measure voltage across the 0.1 ohm resistor. Once voltage is
P7
measured, power can be calculated. For more information, refer to
Measurements" on page
Differential In/Out Connectors (P8–9)
The differential in and out connectors (
tion of the AD1939 codec via XLR connectors. A standard, off the shelf
DB25 connector to XLR cables is required; the cable details can be found
in the following table.
Part Description
25-position DB25 socket
Snake (8)XLRF-25P 9.9'
Snake (8)XLRM-25P 9.9'
2-28
) is used to measure the processor's I/O
P6
P6
1-27.
) is used to measure voltage and current
P7
1-27.
Manufacturer
TYCO
Mating Cables
HOSA
HOSA
ADSP-21479 EZ-Board Evaluation System Manual
is
, and the power flows through the
ON
is
, and the power flows
P7
ON
) are intended for an evalua-
P8–9
Part Number
1734350-2
DTF-803
DTM-803
and
P7
"Power Measure-
"Power
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-21479 EZ-Board and is the answer not in the manual?
Questions and answers