Table of Contents
Advertisement
VDDRTC Power Connector (P3)
The VDDRTC power connector (
I/O voltage and current. By default,
the two-pin IDC header. To measure power, remove the jumper on
and measure voltage across the 0.1 ohm resistor. Once voltage is mea-
sured, power can be calculated. For more information, refer to
Measurements" on page
Shift Register Interface Connector (P4)
The shift register interface connector (
register interface of the processor. A user can use this connector to probe
the signals or can purchase a standard 2 mm ribbon cable if the signals are
needed off the board. For more information, refer to
face" on page
1-18.
Part Description
2 mm 13 x 2 male
6" 2 mm cable 13 x 2
Power Connector (P5)
The power connector (
the EZ-Board.
Part Description
0.65 mm power jack
5.0VDC@3.6A power supply
ADSP-21479 EZ-Board Evaluation System Manual
ADSP-21479 EZ-Board Hardware Reference
P3
1-27.
Manufacturer
SAMTEC
Mating Cable
SAMTEC
) provides all of the power necessary to operate
P5
Manufacturer
CUI
Mating Power Supply (shipped with the EZ-Board)
GLOBTEK
) is used to measure the processor's
is
, and the power flows through
P3
ON
) provides signals for the shift
P4
"Shift Register Inter-
Part Number
ETMM-113-02-L-D-SM
TCSD-13-D-06.00-01
Part Number
045-0883R
GS-1750(R)
P3
"Power
2-27
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-21479 EZ-Board and is the answer not in the manual?
Questions and answers