Bilanciai DD1010 FLYNET Use, Maintenance And Installation Manual page 37

Divisions
Stability Signal
Digital Filter
SECONDARY PARAMETERS
Capacity (Secondary)
Range1 Capacity (Secondary)
Range2 Capacity (Secondary)
Division (Secondary)
Unit of measurement
(Secondary)
FIELDS
Fields
DD1010 FLYNET
1 may vary while the weight stable signal is maintained. On
indicators subject to metrical verification, this parameter must
2 be set to 0 (zero) or 1.
4
Very fast (5 Speed at which the stable weight signal is displayed.
e) Indicates how many equal consecutive readings are
necessary to obtain the stable weight signal. These
Fast
consecutive readings may vary according to the number of
(10 e)
divisions indicated in the previous field. This parameter is
also related to the setting of the digital filter parameter.
Slow
(20 e)
Very slow
(40 e)
Allows adding or not a digital filter. It actually enables the addition or not of a
software processing for filtering the output values from the analogue/digital
converter. The higher the number, the greater the filtering.
No, 4, 8, 16, 32, 64, 128,
Filter 2hz, Filter 2hz+
average, Filter 5hz+
average, Filter 5hz and
ADVANCED.
ADVANCED
Capacity
Range1 Capacity
Range2 Capacity
Division
Unit of measurement
Defines the number of weighing ranges into which the nominal
capacity of the instrument is divided.
It is possible to select:
35
Selectable parameters, 4 additional
parameters are available by setting
"ADVANCED".
Number of values
per Average
Number of fields per
average skip
FIR Filter
High monotony filter
Size of averaged
values table
Value to determine
when to delete the
average.
no, 2Hz/60db,
5Hz/60db, 2Hz/100db
Enables statistical
processing on correct
weight.
Do not use in case of
dynamic weighing.