Power Mode Transitions; General; Power On Projector - Barco F80 User Manual

Mode
ON (normal)
READY
ECO (Standby)
Energy consumption is significantly lowers in ECO (Standby) mode: only <0.5W if network is not
plugged in and 2W with network (Wake-on-LAN).
In ECO (Standby) mode, remote power up (Wake-on-LAN) and local power up (button) are
supported.

4.3 Power mode transitions

4.3.1 General

Transition Diagram
This diagram shows all modes available on the projector (unplug, ON, READY, ECO), and the actions
necessary to change mode.
ECO Powr
ON ON
JSON ASCII
Image 4–2
-
Projector mains powered
-
Auto transition after x minutes if ECO mode enables
-
Press power On/Off button, remote On/Off button

4.3.2 Power on projector

If not already connected, connect the female side of the power cord with the power input socket of
the projector. For more details see section dedicated to the power cord installation.
ECO
Stby
ECO
ON
ON
ASCII
JSON
READY
ON
OFF
ON
ON
JSON
JSON
ON
Description
Projector is booted up and the light source is on
Projector is booted up but the light source is off
Light source is switched off and projector electronics
are powered down
-
Wake on LAN (WOL)
-
JSON command (Power on, Power off, Go to Eco)
-
Stby OFF
ON ON
ASCII JSON
ASCII command (power, stby) received via RS-232
Getting Started
1%
50%
50%
R5906852 /06 F80 35